User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Basic Installation and Configuration 3-3
202-10078-01
Default Factory Settings
When you first receive your WAG302, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
“WAG302 front panel” on page 2-6.
FEATURE FACTORY DEFAULT SETTINGS
User Name (case sensitive) admin
Password (case sensitive) password
Operating Mode Access Point
Access Point Name netgearxxxxxx where xxxxxx are the last six
digits of the wireless access point's MAC address
Built-in DHCP client
Built-in DHCP server
DHCP client disabled
DHCP server disabled
IP Configuration
(if DHCP server is unavailable)
IP Address: 192.168.0.230
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
11a Network Name (SSID) NETGEAR_11a
11g Network Name (SSID) NETGEAR_11g
Broadcast Network Name (SSID Enabled
802.11a Radio Frequency Channel 52
802.11g Radio Frequency Channel 11
AutoCell RF Management
AutoCell Enhanced RF Security ‘stealth’ mode
Enabled
Disabled
WEP/WPA Disabled
Restricting connectivity based on MAC Access
Control List
Disabled
Spanning Tree Protocol Enabled
Time Zone GMT
Time Zone Adjust for Daylight Saving TIme Disabled
SNMP Enabled but Trap forwarding is disabled
Secure Telnet Enabled