User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Introduction 2-7
202-10078-01
Rear Panel
Figure 2-2: WAG302 rear panel
• Left and Right Detachable Antenna
The WAG302 provides two detachable antennas (2.4 GHz and 5 GHz).
LINK/ACT LAN Ethernet LAN Link Activity Indicator
Off Indicates no Ethernet link detected.
Green On 100 Mbps Fast Ethernet link detected, no activity.
Green Blink Indicates data traffic on the 100Mbps Ethernet LAN.
Amber 0n 10 Mbps Ethernet link detected, no activity.
Amber Blink Indicates data traffic on the 10Mbps Ethernet LAN.
802.11a WLAN Wireless LAN Link Activity Indicator (5 GHz)
Off Indicates no wireless link activity.
Green Blink Wireless link activity.
802.11g WLAN Wireless LAN Link Activity Indicator (2.4 GHz)
Off Indicates no wireless link activity.
Green Blink Wireless link activity.
LED DESCRIPTION