User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
IC / FCC addition Statement:
This device is a collocated Access Point(AP), and the two transmitters could be
transmitting at the same time.
- that the device for the band 5150-5250 MHz is only for indoor usage to reduce
potential for harmful interference to co-channel Mobile Satellite systems;
- the maximum antenna gain permitted (5250-5350 MHz devices) to comply with the
EIRP limit.
Additional Antenna informations:
2.4GHz used antenna list :
Netegar Antenna
Model
Manufacture Model Antenna Type.
Antenna gain
Collocate Cable type
ANT24O5 SENAO NAP-2405(N) Ceiling 5 dBi ACC-10314-01,02,03,04 or 05
ANT24P9 SENAO NAP-2409(N) GP Omni-directional 9 dBi ACC-10314-04 or 05
ANT24P12 SENAO NAP-2412(N) GP Omni-directional 12 dBi ACC-10314-04 or 05
ANT24D18
SENAO NAP-
2418(N)
Patch 18 dBi ACC-10314-05