User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
C-4 Command Line Reference
202-10078-01
get set del keyword Description
--- --- --- ---------------------- -------------------------------
[X] [X] | |-sec --wireless WPA global key update interval (i
| | n seconds)
[X] [X] | ‘-pkt --wireless WPA global key update interval (i
| n 1000 packets)
[X] [X] ‘-autocell
[X] [X] |-mode --autocell mode
[X] [X] |-super privacy --avoid other wlan
[X] [X] ‘-refresh --the interval to force refresh autocell
[X] password --system password
[X] reboot --reboot system
[X] exit --logout from CLI