Arlo Pro Quick Start Guide 1
What’s Included Base station AC power adapter Ethernet cable Base station Welcome Thank you for choosing Arlo Pro. Getting started is easy.
1 Insert the Battery Into Your Camera a. Unlock the battery compartment by pressing and holding the latch. b. Gently pull the battery door back to open the compartment. c. Align the battery contacts. d. Insert the battery. 2 Get the App For the best experience, download the Arlo app for your smartphone by scanning this QR code or searching for Arlo in the app store. https://arlo.netgear.com e. 4 Close the battery door. Note: The Arlo Pro battery is fully charged when it leaves the factory.
3 Connect Your Base Station to the Internet a. 6 Connect the base station to your router using an Ethernet cable. b. Connect the base station AC adapter to your base station and plug it in. c. Turn the base station on by pressing the On/Off button. The Power LED and Internet LED on the front of the base station light green in about two minutes.
4 Get an Account Launch the app from your smartphone and tap the New System Setup button. Follow the onscreen instructions. 8 Available AFTER beta 5 Or from a computer, visit https://arlo.netgear.com and follow the onscreen instructions. Sync Your Cameras With the Base Station a. Bring the camera within 1 to 3 feet (30 to 100 centimeters) of the base station. Note: Cameras must be synced one at a time.
b. Press the Sync button on the top of the base station for about two seconds and then release the button. A blue LED on the camera blinks slowly when the sync process starts. The blue LED blinks rapidly to confirm syncing. The camera is ready for viewing. c. Wait for the Sync Status LED to blink green. d. Press the Sync button on top of the camera for about two seconds and then release the button. The LED blinks amber if the sync is not successful. You must repeat the sync process.
6 Place or Mount Your Cameras You can place your camera on a shelf or other flat surface, or you can mount it to the wall. Tip: Use the Arlo app in Position mode (found in Camera Settings) to help aim the camera. 7 Charge Your Arlo Pro Battery The Arlo Pro battery is fully charged when it leaves the factory. ¾¾ To recharge the battery: a. Connect the power adapter cable to the camera power adapter. Note: You must use an Arlo Pro power adapter and cable to charge the battery. b.
You’re Done! Base Station LED Guide Congratulations! Your Arlo System is set up and ready to go. To view useful tutorial videos, find troubleshooting tips, or get support, visit https://www.arlo.com/support/. 14 Power Internet Camera Green The base station is powered on. Green The base station is connected to the Internet. Green Cameras are connected to the base station. Blinking green A firmware update is in progress. DO NOT TURN OFF THE BASE STATION OR CAMERAS.
©NETGEAR, Inc., NETGEAR, the NETGEAR Logo, and Arlo are trademarks of NETGEAR, Inc. Any non‑NETGEAR trademarks are used for reference purposes only. Compliance For the current EU Declaration of Conformity, visit http://kb.netgear.com/app/answers/detail/a_id/11621/. For regulatory compliance information, visit http://www.netgear.com/about/regulatory/.
