Owner's Manual

030-300613 Rev A 121 August 2009
User Guide VersaLink Wireless Gatewa
y
(
Model 7500
)
Selection box Displays the devices available to share the Single Static IP address the ISP has
assigned the Gateway. The names listed in the select box will be populated by the
Gateway’s DHCP server based on DHCP requests. If a device’s name cannot be
determined, the current IP address of the device will be placed in the list.
• When the feature is enabled, the active machine will be highlighted in the
select box and displayed at the bottom of the screen with the Disable
button.
• When the feature is disabled, no device in the select box will be
highlighted, and the Enable button will be available.
• When User Configured PC is selected, a local PC must be configured
manually with the WAN IP address as its Ethernet adapter’s IP address.
To enable Single Static IP, select a device that will share your Single Static IP from the options listed in the
selection box, click Enable and then OK. Your Gateway will be reset, and the new configuration will take effect.
After a brief delay, the Home screen will appear. Confirm that you have a DSL sync and that your PPP session
displays UP. (If necessary, click connect in the Home > Connection Overview screen to establish a PPP session.)
Select Advanced > Single Static IP to confirm that Single Static IP has been enabled, as shown in the following
screen.
IMPORTANT: After you enable Single Static IP, reboot your computer to allow the changes to take effect.
NOTE: If you chose to enable User Configured PC, wait for the Gateway to reset, and then manually type the
WAN IP, Gateway, and Subnet mask addresses you obtained from your ISP into a PC.
To disable Single Static IP, select a device that will share your Single Static IP from the options listed in the
window, click Disable and then OK. Your Gateway will be reset, and the new configuration will take effect.