Owner's Manual

ManualsBrandsNetgear ManualsModemsNetgear VersaLink7500

101

102

103

104

105

106

107

108

109

110

030-300613 Rev A 108 August 2009

User Guide VersaLink Wireless Gatewa

(

Model 7500

)

Status

Displays the status of your VC (Virtual Connection). This field must display

“Enable” in order to allow edits to the VC settings.

PPPoE Settings

DNS Primary Displays the DNS Primary address for resolving machine names, which is provided

by your ISP.

DNS Secondary Displays the DNS Secondary address for resolving machine names, which is

provided by your ISP.

MRU/MTU Negotiation Click this check box to enable or disable MRU/MTU Negotiation. If enabled, the

Maximum Received Unit (MRU) would enforce MRU negotiations. By default,

MRU/MTU Negotiation is disabled (unchecked). Note: Enable this option only at

your ISP’s request.

Size Displays the size of the MRU.

LCP Echo Disable Click this check box to enable or disable LCP Echo Disable. If checked, this option

will disable the Gateway LCP Echo transmissions. By default, LCP Echo Disable is

disabled (checked).

LCP Echo Failures Displays the number of continuous LCP echo non-responses received before the

PPP session is terminated. This number must be between 1 and 30 inclusive.

LCP Echo Duration Displays the interval between LCP Echo transmissions with responses. This number

must be between 5 and 300 seconds inclusive and greater or equal to LCP Echo

Retry Duration.

LCP Echo Retry Duration Displays the interval between LCP Echo after no response. This number must be

between 5 and 300 seconds inclusive.

Tunneling Click the option to enable or disable the Tunneling feature. If Enabled, this option

allows PPP traffic to be bridged to the WAN. By default, Tunneling is enabled.

Note: Tunneling is available in PPPoE mode only.

Proxy ARP Click the option to enable or disable the Proxy ARP feature. When enabled, the

Gateway replies to WAN ARPs for Public LAN Addresses. By default, Proxy ARP

is disabled.

PPPoA Settings