Owner's Manual

030-300613 Rev A 107 August 2009
User Guide VersaLink Wireless Gatewa
y
(
Model 7500
)
14.4.4.1 VC 1 Configuration
The following screen will appear if you click the Edit button from the VCs screen (Advanced > WAN > VCs >
Edit). This screen allows you to edit your VCs. If you change the settings in this screen, click set VC and then OK.
If you click Cancel, the screen will return to its previous settings.
VC 1 Configuration
VPI
Displays the VPI (Virtual Path Indicator) value for a particular VC, which is defined
by your ISP.
VCI
Displays the VCI (Virtual Channel Indicator) value for a particular VC, which is
defined by your ISP.
PCR
Displays the Peak Cell Rate (PCR): The maximum rate at which cells can be
transmitted across a virtual circuit, specified in cells per second and defined by the
interval between the transmission of the last bit of one cell and the first bit of the
next. This value is a percentage of the current data rate; for example:
• 100 allows this VC to use 100% of the available bandwidth.
• 80 allows this VC to use 80% of the available bandwidth.
By default, PCR is 100.
QoS Click this drop-down menu to select the Quality of Service (QoS). The selections
available are determined by your ISP.
Protocol
Note: The configuration
specified by your ISP will
determine which
Protocols are available to
you.
Click this drop-down menu to select the Protocol to be used. The selections
available are determined by your ISP.
• PPPoA: Point to Point Protocol over ATM (Asynchronous Transfer Mode)
• PPPoE: Point to Point Protocol over Ethernet
• Bridge: Bridge Protocol