Owner's Manual

030-300613 Rev A 102 August 2009
User Guide VersaLink Wireless Gatewa
y
(
Model 7500
)
DHCP Start Address (if DHCP is
enabled for Public LAN)
Displays the first IP address that the DHCP server will provide to assign
IP addresses to local devices.
DHCP End Address (if DHCP is
enabled for Public LAN)
Displays the last IP address that the DHCP server will provide for
automatic configuration of local devices.
DHCP Lease Time (if DHCP is
enabled for Public LAN)
Displays the DHCP lease time in days/hours/minutes/seconds. This is the
amount of time the provided addresses will be valid, after which the
DHCP client will usually re-submit a request. DHCP Lease Time must be
greater than 10 seconds (seconds must be between 0 and 59; minutes must
be between 0 and 59; and hours must be between 0 and 23). By default,
DHCP Lease Time is set to 01:00:00:00.
14.4 WAN (Wide Area Network)
This section discusses the WAN (Wide Area Network) screens (Connection Overview, ATM Loopback, VersaPort,
VCs, WAN Detection, QoS, Routes, RIP, and Dynamic DNS) of your Gateway and guides you through the
configurable settings.
14.4.1 Connection Overview
The following screen will appear if you select Advanced > WAN > Connection Setup from the main menu. Please
refer to section 7, “Accessing Your Gateway,” for detailed information on using this screen.