User manual

M-FE116NA-1 QCARD
The instructions provided in this guide are for installing and using the Model
FE116 hub
.
LEDs
There are two LEDs on the front panel of the hub and two on each vista
100BASE-T network port (RJ-45 connector) that allow you to monitor the status
of the hub and the network. The table describes the activity of the LEDs.
Label Color Activity Description
Pwr (power) Green On Power is supplied to the hub.
Col (collision) Amber Blinking Data collision is occurring on the
network. Note that occasional collisions
are normal.
Link/Rx (Located on
the top left corner
of each vista network
port)
Green On
Blinking
The link between this port and the
connected device is good.
There is incoming data on the port.
Part (partition)
(Located on the top
right corner of each
vista network port)
Amber On The port is partitioned because of
excessive collisions.
Product Illustration
Front Panel of the Model FE116 Hub
8493FA
Pwr
1234 1234 9101112 13 14 15 16
Link/Rx Part
Normal/Uplink
Col
100 Mbps
FAST
100BASE-FAST ETHERNET HUB FE116
Col LED
Pwr LED
vista 100BASE-T
network ports
Normal/Uplink
push button