Quick Reference Guide

ProSafe Wireless-N VPN Firewall SRXN3205 Reference Manual
Wireless Configuration 4-17
v1.0, January 2010
7. If you want to fine tune the overall performance of the Wireless Settings for your environment,
see “Configuring Advanced Wireless Settings” on this page.
Configuring Advanced Wireless Settings
Use the Wireless Advanced Options screen to configure and enable various wireless LAN
parameters for all of the 802.11a/n and 802.11b/g/n modes. The default wireless LAN parameters
usually work well. However, you can use these settings to fine-tune the overall performance of
your Wireless Settings for your environment.
To configure advanced wireless features:
1. Select Network Configuration > Wireless Settings from the main/submenu.
2. Select Advanced to the right of the Wireless Settings tab. The Advanced Wireless Options
screen is displayed.
Note: By default, the VPN firewall is configured with the DHCP client enabled. If
your network uses dynamic IP addresses, you must change this setting. To
connect to the VPN firewall after the DHCP server on your network assigns it
a new IP address, enter the VPN firewall name into your Web browser. The
default VPN firewall name is netgearxxxxxx, where xxxxxx represents the last
6 bytes of the MAC address. The default name is printed on the bottom label of
the VPN firewall.
Figure 4-3