Quick Reference Guide

ProSafe Wireless-N VPN Firewall SRXN3205 Reference Manual
8-8 Managing Users, Authentication, and Certificates
v1.0, January 2010
To restrict logging in based on IP address:
1. In the Action column of the List of Users table, click Policies adjacent to the user policy you
want to configure. The Login Policies screen is displayed.
2. Select the by Source IP Address tab. The by Source IP Address screen is displayed.
3. In the Defined Addresses Status section, select:
•the Deny Login from Defined Addresses to deny logging in from the IP addresses that
you will specify
•the Allow Login only from Defined Addresses to allow logging in from the IP addresses
that you will specify.
4. Click Apply.
5. To specify a single IP address, select IP Address from the Source Address Type pull-down
menu and enter the IP address in the Network Address/IP address field.
6. To specify a subnet of IP addresses, select IP Network from the Source Address Type pull-
down menu. Enter the network address and netmask length in the Network Address/IP
address field.
7. Click add to move the defined address to the Defined Addresses table.
8. Repeat these steps to add additional addresses or subnets.
Figure 8-7