User Manual

Figure 5. Orbi Pro satellite label

Connect Your Router

If you want to connect your Orbi Pro router to an existing gateway, we recommend that you turn off your

existing gateway’s WiFi.

To cable your router:

1. Unplug your modem’s power, leaving the modem connected to the wall jack for your Internet service.

If your modem uses a battery backup, remove the battery, and then put the battery back in.

2. Plug in and turn on your modem.

3. Connect your modem to the Internet port of your router with the Ethernet cable that came with your

router.

4. Connect the power adapter to your router and plug the power adapter into an outlet.

5. If the Power LED does not light, press the Power On/Off button on the rear panel of the router.

Place Your Satellite

Your satellites must be within range of your router’s WiFi signal in order for it to sync with the router. Use

the satellite’s ring LED to help you determine where to place your satellite. The following images show

examples of where to place your Orbi Pro router and satellites.

Overview

Orbi Pro