User Manual

6.
Reset button. For more information, see Reset the satellite to factory defaults on
page 28.
7.
Sync button. For more information, see Sync your satellite using the Sync button
on page 14.
Power LED
The Power LED is located to the left of the LED bar on the top panel. The following table
describes the behavior for the Power LED bar.
Table 1. Power LED behavior
LED behaviorColor
Power is on. This is the normal Power LED behavior when the satellite is on.Solid green
A firmware upgrade is in progress or the satellite is resetting to factory default settings.Blinking amber
PoE power is not at the 802.3at (PoE+) level, which is required if you use a PoE connection. For
more information, see You use PoE power and the Power LED is solid red on page 34.
Solid red
The firmware is corrupted. For more information, see The Power LED is blinking red on page
34.
Blinking red
Power is not supplied.Off
LED Bar
The LED bar is located to the right of the Power LED on the top panel. The following
tables describe the behavior for the LED bar.
Table 2. LED bar behavior
LED behaviorColor
The satellite is booting.Pulsing white
The satellite is trying to sync with the Orbi Pro router. The LED might pulse white for
about six minutes. After the LED pluses white, it lights blue, amber, or magenta. See the
next table for more information.
Pulsing white after you
press the Sync button
The satellite is ready to sync with the Orbi Pro router.Solid white
After you press the Sync button, the LED bar pulses white. Then, for about three minutes,
the LED bar lights one of colors described in the following table. After three minutes,
the LED bar turns off.
User Manual9Overview
Orbi Pro Ceiling Satellite