User Manual
Table Of Contents
- Contents
- 1. Overview
- 2. Manage Your Orbi Pro Ceiling Satellite
- Update the Orbi Pro Ceiling Satellite and Orbi Pro router firmware
- Enable the Sync button
- Turn the satellite LEDs on or off
- Change the satellite device name
- View satellite information in the router web interface
- View the satellite status in the satellite web interface
- Reset the satellite to factory defaults
- About link aggregation
- 3. Troubleshooting
- A. Supplemental Information
•
Solid white. The satellite finished booting and is ready to sync with your router.
4.
Press the Sync button on the back of your satellite, and within two minutes, press
the Sync button on the back of your router.
5.
Wait for the satellite to sync with the router.
The LED bar on the satellite lights pulsing white while it attempts to sync with your
router. It might take about six minutes for your satellite to sync.
After the LED bar lights white, it lights one of the following colors for about three
minutes and then turns off.
LED BehaviorColor
The Orbi Pro router and satellite synced, and the connection between the router and
satellite is good.
Blue
The Orbi Pro router and satellite synced, but the connection between the router and
satellite is only fair. Consider moving the satellite closer to the router.
Amber
The Orbi Pro router and satellite did not sync. Move the satellite closer to the router
and try again.
Magenta
6.
Do one of the following:
•
The sync failed. If the sync failed, try to sync again by repeating Step 4 and Step
5. If the sync keeps failing, try a different location or position.
•
The sync is successful. If the sync is successful, move the satellite to the location
where you want to install it and continue with Step 7.
7. At the new location, connect your satellite to a power source.
For more information, see Step 2.
8. At the new location, resync the satellite with the Orbi Pro router by repeating Step
4 and Step 5.
If the LED bar lights blue or amber, the satellite synced successfully. If the LED bar
lights blue, the connection is good. If the LED bar lights amber, consider moving
the satellite closer to the router so that you can get a good connection instead of a
fair connection.
9.
If the LED bar pulses magenta or lights magenta, the satellite did not resync. Do one
of the following:
•
The LED bar pulses magenta. If you press the Sync button and the satellite’s
LED bar pulses magenta, this LED behavior indicates that the Sync button is
User Manual33Troubleshooting
Orbi Pro Ceiling Satellite