User Manual
Table Of Contents
- Contents
- 1. Overview
- 2. Manage Your Orbi Pro Ceiling Satellite
- Update the Orbi Pro Ceiling Satellite and Orbi Pro router firmware
- Enable the Sync button
- Turn the satellite LEDs on or off
- Change the satellite device name
- View satellite information in the router web interface
- View the satellite status in the satellite web interface
- Reset the satellite to factory defaults
- About link aggregation
- 3. Troubleshooting
- A. Supplemental Information
You can set up a link aggregation connection between the satellite and a switch by
doing the following:
1. On the switch, configure either static link aggregation or Link Aggregation Control
Protocol (LACP) on the two Ethernet ports that you intend to use for the LAG
connection to the satellite.
CAUTION: To prevent a network loop, configure the switch ports before connecting
them to the satellite ports.
2. Connect the two Ethernet ports on the switch to the LAN 1 and LAN 2 ports on the
satellite.
User Manual29Manage Your Orbi Pro Ceiling
Satellite
Orbi Pro Ceiling Satellite