User Manual
Table Of Contents
- Contents
- 1. Overview
- 2. Manage Your Orbi Pro Ceiling Satellite
- Update the Orbi Pro Ceiling Satellite and Orbi Pro router firmware
- Enable the Sync button
- Turn the satellite LEDs on or off
- Change the satellite device name
- View satellite information in the router web interface
- View the satellite status in the satellite web interface
- Reset the satellite to factory defaults
- About link aggregation
- 3. Troubleshooting
- A. Supplemental Information
Table 3. Sync colors
LED BehaviorColor
The Orbi Pro router and satellite synced, and the connection between the router and satellite
is good.
Blue
The Orbi Pro router and satellite synced, and the connection between the router and satellite
is fair. Consider moving the satellite closer to the router.
Amber
The Orbi Pro router and satellite did not sync. Move the satellite closer to the router and
try again.
Magenta
If the LED bar pulses magenta for about 30 seconds, the satellite’s Sync button is disabled.
Log in to the router, enable the Sync button, and repeat the sync process. For more
information, see Enable the Sync button on page 23.
Pulsing
magenta
Satellite label
The satellite label shows the WiFi network name (SSID), network key (password), the
satellite’s serial number, and the satellite’s MAC address. The following figure is an
example of the label.
Figure 4. Satellite label
Mount the satellite on a drop ceiling or wall
You can mount the satellite on a drop ceiling or on a wall. The package contains the
components for either mounting method.
Before mounting the satellite, first set up and test the satellite with your Orbi Pro router
to verify WiFi network connectivity.
User Manual10Overview
Orbi Pro Ceiling Satellite