User Manual
Table Of Contents
- S3300 Smart Managed Pro Switch
- Contents
- 1. Getting Started
- Getting Started with the NETGEAR Switch
- Switch Management Interface
- Connect the Switch to the Network
- Discover a Switch in a Network with a DHCP Server
- Discover a Switch in a Network without a DHCP Server
- Configure the Network Settings on the Administrative System
- Access the Management Interface from a Web Browser
- Understand the User Interfaces
- Interface Naming Convention
- Configuring Interface Settings
- Online Help
- Registration
- 2. Configure System Information
- 3. Configuring Switching
- 4. Configuring Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Maintenance
- 8. Monitoring the System
- A. Configuration Examples
- B. Hardware Specifications and Default Values
Configure System Information
69
S3300 Smart Managed Pro Switch
Figure 42. Green Ethernet Detail
2. From the Interface list, select the interface to configure the Green Ethernet mode settings.
3. Enable
or disable the Energy Detect Admin Mode on the port. When energy detect mode
enabled, and a port link is down, the PHY automatically goes down for a short period of
time, and then wakes up to check link pulses. This will allow performing auto-negotiation and
saving power consumption when no link partner is present. The default value is Disabled. If
Energy Detect Admin Mode is not supported, then N/A is displayed.
4. EEE Adm
in Mode. Enable or disable the Energy Efficient Ethernet (EEE) Admin Mode
on the port. When EEE mode is enabled, the port transitions to low-power mode during link
idle conditions. The default value is Disabled. If EEE Admin Mode is not supported, then
N/A is displayed.