User Manual
Table Of Contents
- S3300 Smart Managed Pro Switch
- Contents
- 1. Getting Started
- Getting Started with the NETGEAR Switch
- Switch Management Interface
- Connect the Switch to the Network
- Discover a Switch in a Network with a DHCP Server
- Discover a Switch in a Network without a DHCP Server
- Configure the Network Settings on the Administrative System
- Access the Management Interface from a Web Browser
- Understand the User Interfaces
- Interface Naming Convention
- Configuring Interface Settings
- Online Help
- Registration
- 2. Configure System Information
- 3. Configuring Switching
- 4. Configuring Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Maintenance
- 8. Monitoring the System
- A. Configuration Examples
- B. Hardware Specifications and Default Values
Table 112. Quality of service
Feature Sets Supported Default
Number of queues 7 N/A
802.1p 1 Enabled
DSCP 1 Disabled
Rate limiting All ports Disabled
Table 113. Security
Feature Sets Supported Default
802.1X All ports Disabled
MAC ACL 100 (shared with IP and IPv6
ACLs)
All MAC addresses allowed
IP ACL 100 (shared with MAC and IPv6
ACLs)
All IP addresses allowed
IPv6 ACL 100 (shared with IP ACL and MAC
ACL)
All IP addresses allowed
Password control access 1 Idle timeout = 5 mins.
Password = “password”
Management security 1 profile with 20 rules for
HTTP/HTTPS
/SNMP access to
allow/deny an IP address/subnet
All IP addresses allowed
Port MAC lock down All ports Disabled
Hardware Specifications and Default Values
371
S3300 Smart Managed Pro Switch
Table 114. System setup and maintenance
Feature Sets Supported Default
Boot code update 1 N/A
DHCP/manual IP 1 DHCP enabled/192.168.0.239
Default gateway 1 192.168.0.254
System name configuration 1 NULL
Configuration save/restore 1 N/A
Firmware upgrade 1 N/A
Restore defaults 1 (web and front-panel button) N/A