User Manual
Table Of Contents
- S3300 Smart Managed Pro Switch
- Contents
- 1. Getting Started
- Getting Started with the NETGEAR Switch
- Switch Management Interface
- Connect the Switch to the Network
- Discover a Switch in a Network with a DHCP Server
- Discover a Switch in a Network without a DHCP Server
- Configure the Network Settings on the Administrative System
- Access the Management Interface from a Web Browser
- Understand the User Interfaces
- Interface Naming Convention
- Configuring Interface Settings
- Online Help
- Registration
- 2. Configure System Information
- 3. Configuring Switching
- 4. Configuring Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Maintenance
- 8. Monitoring the System
- A. Configuration Examples
- B. Hardware Specifications and Default Values
Configuring Quality of Service
232
S3300 Smart Managed Pro Switch
Figure 95. DiffServ Class Configuration Criteria
2. Define the criteria to associate with a DiffServ class:
• Matc
h Every. This adds to the specified class definition a match condition whereby all
packets are considered to belong to the class.
• Reference Cla
ss. Selects a class to start referencing for criteria. A specified class
can reference at most one other class of the same type.
• Class of
Service. Select the field and enter a class of service 802.1p user priority
value to be matched for the packets. The valid range is 0–7.
• VLAN. Select the fie
ld and enter a VLAN ID to be matched for packets. The VLAN ID
range is 1–4093.
• Ethernet T
ype. This lists the keywords for the Ether Type from which one can be
selected.
• Source MAC Address. This is the
source MAC address specified as six, two-digit
hexadecimal numbers separated by colons.
• Source MAC Mask.
This is a bit mask in the same format as MAC Address indicating
which part(s) of the source MAC Address to use for matching against packet content.
• Destinati
on MAC Address. This is the destination MAC address specified as six,
two-digit hexadecimal numbers separated by colons.