User Manual
Table Of Contents
- S3300 Smart Managed Pro Switch
- Contents
- 1. Getting Started
- Getting Started with the NETGEAR Switch
- Switch Management Interface
- Connect the Switch to the Network
- Discover a Switch in a Network with a DHCP Server
- Discover a Switch in a Network without a DHCP Server
- Configure the Network Settings on the Administrative System
- Access the Management Interface from a Web Browser
- Understand the User Interfaces
- Interface Naming Convention
- Configuring Interface Settings
- Online Help
- Registration
- 2. Configure System Information
- 3. Configuring Switching
- 4. Configuring Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Maintenance
- 8. Monitoring the System
- A. Configuration Examples
- B. Hardware Specifications and Default Values
Configuring Routing
210
S3300 Smart Managed Pro Switch
Configure IP Settings
For information about how to configure and display IP routing data, see the following
sections:
• IP Configuration on p
age 210
• VLAN Routing Wizard on p
age 214
• IP Statistics on p
age 211
IP Configuration
Use the IP Configuration screen to configure routing parameters for the switch.
To enable routing on the switch:
1. Select Routing > IP > IP Configuration.
2. Next to Rou
ting Mode, select Enable.
You must enable routing for the switch before you can route through any of the interfaces.
Routin
g is also enabled or disabled per VLAN interface. The default value is Disable.
3. Click the Appl
y button.
The following table describes the IP config
uration information displayed on the screen.
Table 78. Global IP Status Information
Field Description
Default Time to Live The default value inserted into the Time-T
o-Live field of the IP header of
datagrams originated by the switch, if a TTL value is not supplied by the
transport layer protocol. The default value is 64.
Maximum Next Hops The maximum number of hops supported by the switch. This is a compile-time
const
ant. The default value is 1.