Quick Reference Guide

Reference Guide for the Model RT338 ISDN Router
8-2 Configuring Dial-In Access
Setting Up Default Dial-In Access
This section describes the default dial-in parameters. The parameters in Menu 13 affect incoming
calls from all remote dial-in users and remote nodes before authentication is completed.
After authentication is completed, if it matches a remote node, the router uses parameters from
that particular remote node.
To configure default dial-in settings:
1.
From the Manager Interface Main Menu, enter 13 to open Menu 13 - Default Dial-in Setup as
shown in Figure 8-1.
Figure 8-1. Menu 13 - Default Dial-in Setup
2.
Enter settings for the default dial-in setup.
Refer to Table 8-1 for information about the fields on the Default Dial-in Setup menu.
3. Press [Enter] at the ENTER to Confirm... prompt to save your selections.
You can press [Esc] at any time to cancel your selections.
Menu 13 - Default Dial-in Setup
Telco Options: IP Address Supplied By:
CLID Authen= None Dial-in User= Yes
IP Pool= No
PPP Options: IP Start Addr= N/A
Recv Authen= CHAP/PAP IP Count(1,2)= N/A
Compression= No
Mutual Authen= No Session Options:
O/G Username= Edit Filter Sets= No
O/G Password= ********
Multiple Link Options:
Max Trans Rate(Kbps)= 128
Callback Budget Management:
Allocated Budget(min)=
Period(hr)=
Press ENTER to Confirm or ESC to Cancel:
Dialin.fm Page 2 Friday, October 6, 2000 5:27 PM