Quick Start Manual

b. If your service provider uses PPPoE, select Encapsulation as PPPoE, and enter these
additional parameters:
– If your connection supports multiple ISPs,enter the Service Name of the one you use.
Otherwise leave Service Name blank.
– Enter the user name and password provided by your ISP.These fields are case sensitive.
– If you wish to change the login timeout, enter a new value in seconds.
Proceed to Step 7.
c. If your service provider is RoadRunner AND you are required to run a RoadRunner login
program, leave Encapsulation as Ethernet and select Service Type as either RR-Manager or
RR-Toshiba. Enter these additional parameters:.
– If your cable modem is Toshiba, select RR-Toshiba.Otherwise select RR-Manager.
– Enter the user name and password provided by your ISP.These fields are case sensitive.
– If RoadRunner provided an authentication server address,enter it as Login Server
IP address. Otherwise, leave this field as 0.0.0.0.
Not all RoadRunner regions require a login program. If your region does not require a login,
leave Service Type as Standard.
7. Click on Next to go to the final Wizard screen shown below.
a. WAN IP Address Assignment: Unless your ISP has assigned a fixed permanent IP address for
your use, select “Get automatically from ISP”. Otherwise, enter your IP Address, Subnet
Mask, and the IP Address of your ISP’s gateway router.