Quick Reference Guide

Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
4-4 Using Your Browser for Configuring the Router
8.
Click on Next to go to the ISP Parameters screen, shown in Figure 4-3 below:
Figure 4-3. Browser-based Setup Wizard, second screen
This screen determines whether a login program will be run.
a.
If your service provider does not require a login program, leave Encapsulation as
Ethernet and proceed to Step 9.
b.
If your service provider uses PPP over Ethernet (PPPoE), select Encapsulation as
PPPoE, and enter these additional parameters:
• If your connection supports multiple ISPs, enter the Service Name of the one you use.
Otherwise leave Service Name blank.
• Enter the user name and password provided by your ISP. These fields are case
sensitive.
• If you wish to change the login timeout, enter a new value in seconds.
Proceed to Step 9.
c.
If your service provider is RoadRunner AND you are required to run a RoadRunner
login program, leave Encapsulation as Ethernet and select Service Type as either
RR-Manager or RR-Toshiba. Enter these additional parameters:.
• If your cable modem is Toshiba, select RR-Toshiba. Otherwise select RR-Manager.
• Enter the user name and password provided by your ISP. These fields are case
sensitive.