Quick Reference Guide

Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
Troubleshooting 9-5
If the path is not functioning correctly, you could have one of the following problems:
• Wrong physical connections
— Make sure the Local LNK/ACT LED is on. If the LNK/ACT LED is off, follow the
instructions in “LNK/ACT LEDs Not On” on page 9-2.
— Check that the corresponding Link LEDs are on for your network interface card and
for the hub ports (if any) that are connected to your workstation and router.
• Wrong network configuration
— Verify that the Ethernet card driver software and TCP/IP software are both installed
and configured on your PC or workstation.
— Verify that the IP address for your router and your workstation are correct and that the
addresses are on the same subnet.