User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Managing Device Security
480
M6100 Web Management User Guide
• IP ACL on page 480
• IP Rules on page 481
• IP Extended Rules on page 483
• IPv6 ACL on page 487
• IPv6 Rules on page 488
• IP Binding Configuration on page 492
• IP ACL Binding Table on page 494
• VLAN Binding Table on page 494
IP ACL
An IP or IPv6 ACL consists of a set of rules which are matched sequentially against a packet.
When a packet meets the match criteria of a rule, the specified rule action (Permit/Deny) is
taken, and the additional rules are not checked for a match. On this menu the interfaces to
which an IP ACL applies must be specified, as well as whether it applies to inbound or
outbound traffic. Rules for the IP ACL are specified/created using the IPv6 ACL Rule
Configuration page.
To display the IP ACL page, click Security
ACL> Advanced IP ACL.
The IP ACL page shows the current size of the ACL table and the maximum size of the ACL
table. The current size is equal to the number of configured IPv4 and IPv6 ACLs plus the
number of configured MAC ACLs. The maximum size is 100.
To configure an IP ACL:
1. The Current Number of ACL displays the current number of the all ACLs configured on
the switch.