User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Configuring System Information
48
M6100 Web Management User Guide
To configure the Green Ethernet interface settings:
1. Specify the Go T
o Interface by entering the Interface in unit/slot/port format and click on
the Go button. The entry corresponding to the specified Interface, will be selected.
2. Select the Port for which data is to be displayed or configured.
3. Use the Auto Power Down Mode selection to enable or disable this option.
The factory
default is enable. When the port link is down the PHY will automatically go down for short
period of time, and then wakes up to check link pulses. This will allow performing
auto-negotiation and saving power consumption when no link partner is present.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. Click Apply to update the configuration on the switch.
Green Ethernet Local and Remote Device Configuration
Use this page to configure the Green Ethernet Mode Local Device and Remote Device
settings.
To access this page, click System Management Green Ethernet Green Ethernet
Detail.