User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Configuring Quality of Service
372
M6100 Web Management User Guide
• trust dot1p
• trust ip-dscp
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
6. If you change any of the settings on the page, click Apply to send the updated configuration
to the switch.
Advanced
From the Advanced link, you can access the following pages:
• CoS Configuration on page 372
• 802.1p to Queue Mapping on page 373 (Advanced)
• IP DSCP to Queue Mapping on page 373 (Advanced
• CoS Interface Configuration on page 374 (Advanced)
• Interface Queue Configuration on page 375 (Advanced)
• CoS Queue Drop Precedence Configuration on page 376
CoS Configuration
To display the CoS Configuration page, click QoS CoS Advanced CoS Configuration.
1. Use Global to specify all CoS configurable interfaces. The option “Global” represents
the most recent global configuration settings.
2. Use Interface to specify CoS configuration settings based per-interface.
3. Use Global T
rust Mode to specify whether to trust a particular packet marking at ingress.
Global Trust Mode can only be one of the following. Default value is trust dot1p.
• untrusted
• trust dot1p
• trust ip-dscp
4. Use Interface T
rust Mode to specify whether to trust a particular packet marking at ingress.
Interface Trust Mode can only be one of the following. Default value is untrusted.
• untrusted
• trust dot1p
• trust ip-dscp