User Manual

Routing
359
M6100 Web Management User Guide
2. In the Group Address field, enter the group IPv6 address prefix transmitted in
Candidate-RP-Advertisements.
3. In the Prefix Length field, enter the group IPv6 Prefix Length transmitted in
Candidate-RP-Advertisements
4. In the C-RP Advertisement
Interval, specify the duration in seconds at which the C-RP
messages are unicast to the Bootstrap Router (BSR). The range is from 1 to 16383
seconds. The default value is 60 seconds. If this field is submitted without any value, the
default value is used.
5. Click Add to add a new Candidate-RP
Address for the PIM router.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7. Click Delete to delete an existing Candidate-RP
Address for the PIM router.
IPv6 PIM Bootstrap Router Candidate Configuration
To display the IPv6 PIM Bootstrap Router (BSR) Candidate Configuration page, click
Routing
 IPv6 Multicast  IPv6 PIM  BSR Candidate Configuration. The following page is
displayed.
 IPv6 PIM BSR Candidate Configuration
1. From the list of interfaces, select the Interface for which data is to be configured or
displayed.
2. Enter the C-BSR Hash Mask Length to be advertised in bootstrap messages.
This hash
mask length will be used in the hash algorithm for selecting the RP for a particular group.
The valid values are from 0 to 128. Default value is 126.
3. In the Priority field, enter the priority of C-BSR.
4. Enter the Advertisement Interval value of the C-BSR in seconds.
The default value is 60.
5. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
6. Click Delete to remove the configured Hash Mask Length, and Priority values and restore
them to the default values.