User Manual

Routing
341
M6100 Web Management User Guide
9. In the Startup Query Count field, enter the number of queries to be sent on startup. The
valid values are 1 to 20. The default value is 2.
10. In the Last Member Query Interval field, enter the last member query interval in tenths of a
second.
This is the maximum response time to be inserted into group-specific queries sent
in response to leave group messages, and is also the amount of time between
group-specific query messages. Valid values are from 0 to 255. The default value is 10. This
value is not used for IGMP version 1.
11. In the Last Member Query Count field, enter the number of queries to be sent on receiving
a leave group report. V
alid values are from 1 to 20. The default value is 2.
12. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
13. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
IGMP Routing Interface Statistics
To display the Multicast IGMP Routing Interface Statistics page, click Routing Multicast 
IGMP
 Routing Interface Statistics. The following page is displayed.
Table 135, Multicast IGMP Routing Interface Statistics describes the non-configurable data
that is displayed.
Click Update to update the page with the latest information on the switch.
Table 135. Multicast IGMP Routing Interface Statistics
Field Description
Interface The interface on which the IGMP is enabled.
IP Address The IP address of the selected interface.
Subnet Mask The subnet mask for the IP address of the selected interface.
Protocol State The operational state of IGMP on the selected interface, either operational or
non-operational.
Querier IP The address of the IGMP Querier on the IP subnet to which the selected
interface is attached.