User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Routing
304
M6100 Web Management User Guide
OSPFv3 Interface Configuration
To display the OSPFv3 Interface Configuration page, click Routing > OSPFv3 > Advanced
> Interface Configuration. The following page is displayed.
Configure the OSPFv3 Interface Configuration settings.
1. In the Go T
o Interface field, enter the Interface in unit/slot/port format and click the Go
button. The entry corresponding to the specified interface will be selected.
2. Select the check box next to the Interface for which data is to be displayed or configured.
3. In the Area ID field, enter the 32-bit integer in dotted decimal format that uniquely identifies
the OSPFv3 area to which the selected router interface connects. If you assign an
Area ID
which does not exist, the area will be created with default values.
4. Configure the Admin Mode by selecting the Enable or Disable option from the list.
The
default value is Disable. You can configure OSPFv3 parameters without enabling OSPFv3
Admin Mode, but they will have no effect until you enable Admin Mode. The following
information will be displayed only if Admin Mode is enabled:
• State
• Designated Router
• Backup Designated Router
• Number of Link Events
• LSA Ack
Interval
• Metric Cost
For OSPFv3 to be fully functional, you must enter a valid IPv6 Prefix/Prefix Length. This
can be done using the CLI ipv6 address command.