User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Routing
245
M6100 Web Management User Guide
IPv6 Static Route Configuration
To display the IPv6 Static Route Configuration page, click Routing IPv6 Advanced
Static Route Configuration. The following page is displayed.
Configure the IPv6 Static Route.
1. In the IPv6 Prefix field, specify the IPv6 prefix for the configured route.
2. In the Prefix Length field, specify the IPv6 prefix length for the configured route
3. Specify the Next Hop IPv6
Address Type by selecting one of the following options from the
list:
• Global IPv6 Address
• Link-Local IPv6
Address. If the Next Hop IPv6 address specified is a Link-Local IPv6
Address, then specify the Interface for the Link-local IPv6 Next Hop Address.
Neighbor State Specifies the state of the neighbor cache entry. Following are the states
for dynamic entries in the IPv6 neighbor discovery cache:
• Incmp — Address resolution is being performed on the entry.A
neighbor solicitation message has been sent to the solicited-node
multicast address of the target, but the corresponding neighbor
advertisement message has not yet been received.
• Reach — Positive confirmation was received within the last Reachable
T
ime milliseconds that the forward path to the neighbor was
functioning properly. While in REACH state, the device takes no
special action as packets are sent.
• Stale — More than ReachableTime milliseconds have elapsed since
the last positive confirmation was received that the forward path was
functioning properly
. While in STALE state, the device takes no action
until a packet is sent.
• Delay — More than ReachableTime milliseconds have elapsed since
the last positive confirmation was received that the forward path was
functioning properly
. A packet was sent within the last
DELAY_FIRST_PROBE_TIME seconds. If no reachability
confirmation is received within DELAY_FIRST_PROBE_TIME
seconds of entering the DELAY state, send a neighbor solicitation
message and change the state to PROBE.
• Probe — A reachability confirmation is actively sought by resending
neighbor solicitation messages every RetransT
imer milliseconds until
a reachability confirmation is received.
Last Updated
Time since the address was confirmed to be reachable.
Field Description