User Manual

Routing
237
M6100 Web Management User Guide
9. In the Duplicate Address Detection Transmits field, specify the number of duplicate
address detection (DAD) transmits on an interface. DAD transmits values must be in the
range 0 to 600. The default is 1.
10. Specify the router advertisement Life T
ime Interval sent from the interface. This value must
be greater than or equal to the maximum advertisement interval. 0 means do not use the
router as the default router. The range of router life time is 0 to 9000. The default is 1800.
11. In the Adv NS Interval field, specify the retransmission time field of router advertisement
sent from the interface.
A value of 0 means the interval is not specified for the router. The
range of neighbor solicit interval is 1000 to 4294967295. The default is 0.
12. In the Adv Reachable Interval field, specify the router advertisement time to consider
neighbor reachable after ND confirmation.
The range of reachable time is 0 to 3600000. The
default is 0.
13. Use the Adv Interval field to specify the maximum time allowed between sending router
advertisements from the interface.
The range of maximum advertisement interval is 4 to
1800. The default value is 600.
14. In the Adv Other Config Flag list, select Enable or Disable to specify router advertisement
other stateful configuration flag. Default value of other config flag is disable.
15. In the Adv Suppress Flag list, select to Enable or Disable router advertisement
suppression on an interface.
The default value of suppress flag is disable.
16. In the Destination Unreachables list, select to Enable or Disable the Mode of Sending
ICMPv6 Destination Unreachables on this interface. If Disabled, then this interface will not
send ICMPv6 Destination Unreachables. By default, the IPv6 Destination Unreachables
mode is enable.
17. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
18. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Table 88, IPv6 Advanced Interface Configuration describes the non-configurable data that is
displayed.
Table 88. IPv6 Advanced Interface Configuration
Field Description
Operational Mode Specifies operational state of an interface. The default value is disable.
Link State Indicates whether the link is up or down.
IPv6 Prefix Configuration
To display the IPv6 Prefix Configuration page, click Routing IPv6  Advanced  Prefix
Configuration. The following page is displayed.