User Manual

Configuring System Information
106
M6100 Web Management User Guide
• LLDP Global Configuration on page 106
• LLDP Interface Configuration on page 106
• LLDP Statistics on page 107
• LLDP Local Device Information on page 109
• LLDP Remote Device Information on page 111
• LLDP Remote Device Inventory on page 112
LLDP Global Configuration
Use the LLDP Global Configuration page to specify LLDP parameters that are applied to the
switch.
To display this page, click System  LLDP  Global Configuration. A screen similar to the
following is displayed.
To configure global LLDP settings:
1. Use T
ransmit Interval to specify the interval in seconds to transmit LLDP frames. The
range is from 5 to 32768 secs. Default value is 30 seconds.
2. Use T
ransmit Hold Multiplier to specify the multiplier on Transmit Interval to assign TTL.
The range is from 2 to 10 secs. Default value is 4.
3. Use Re-Initialization Delay to specify the delay before re-initialization.
The range is from 1
to 10 secs. Default value is 2 seconds.
4. Use Notification Interval to specify the interval in seconds for transmission of notifications.
The range is from 5 to 3600 secs. Default value is 5 seconds.
5. Click Cancel to cancel the configuration on the screen. Resets the data on the screen to the
latest value of the switch.
6. Click Apply to send the updated configuration to the switch and cause the changes to take
ef
fect on the switch but these changes will not be retained across a power cycle unless a
save is performed.
LLDP Interface Configuration
To display this page, click System  LLDP  Interface Configuration. A screen similar to the
following is displayed.