Quick Start Manual

Hardware Installation

NETGEAR Managed Switch

The site where you install the RPS can affect its performance. Before installing the switch or

switches, make sure that the chosen installation location meets the following site

requirements.

Install the RPS

You can install the RPS on a flat surface or in a standard 19-inch rack.

Install the RPS on a Flat Surface

The RPS ships with four self-adhesive rubber footpads. Stick one rubber footpad on each

of the four concave spaces on the bottom of the RPS. The rubber footpads cushion the

RPS against shock and vibrations.

Install the Switch in a Rack

 To install the RPS in a rack using the 19-inch rack-mount kit supplied with the RPS:

1. Attach the supplied mounting brackets to the side of the RPS.

Table 1. Site requirements for RPS location

Requirements

Mounting Desktop installations: Provide a flat table or shelf surface.

Rack-mount installations: Use a 19-inch (48.3-centimeter) EIA standard

equipment rack that is grounded and physically secure. You need the

rack-mount kit supplied with the RPS.

Access Locate the RPS in a position that lets you access the front and rear connections

and view the front panel LEDs.

Power source Provide a power source within 6 feet (1.8 meters) of the installation location.

Power specifications for the RPS are shown in Appendix A. Be sure that a wall

switch does not control the AC outlet. A wall switch can accidentally turn off

power to the outlet and the RPS.

Environment Install the RPS in a site free from strong electromagnetic field generators (such

as motors), vibration, dust, and direct exposure to sunlight.

Temperature The ambient RPS operating temperature range is 0º to 50ºC (32º to 122ºF).

Keep the RPS away from heat sources such as direct sunlight, warm air

exhausts, hot-air vents, and heaters.

Operating humidity Install the RPS in a dry area with a maximum relative humidity of 90%,

noncondensing.

Ventilation Do not restrict airflow by covering or obstructing air inlets on the sides of the

RPS. Keep at least 2 inches (5.08 centimeters) free on all sides for cooling. Be

sure that there is adequate airflow in the room or wiring closet where you intend

to install the RPS.