User Manual
Table Of Contents
- Contents
- 1. Getting Started
- Start Using Your ReadyNAS System
- Additional Documentation
- Supported ReadyNAS Systems
- Supported Operating Systems
- Supported Browsers
- Diskless Systems
- Basic Installation
- Upgrade Pre-6.2 ReadyNAS Firmware for Use With ReadyCLOUD
- Discover and Set Up Your ReadyNAS Using ReadyCLOUD
- Local Setup Wizard
- Admin Page
- Access the Local Admin Page
- Register Your System
- Five Levels of Protection
- The ReadyNAS Community
- Safe Mode
- 2. Volume Configuration
- Basic Volume and RAID Concepts
- ReadyTIER, Tiers, Data, and Metadata
- Manage Volumes
- Change RAID Mode
- View the Status of a Volume
- Configure the Checksum Function
- Format Disks
- Create and Encrypt a Volume
- Delete a Volume
- Name a USB Drive
- Expand Storage Capacity
- Add Protection to a Volume
- Add Protection to a Flex-RAID Volume
- Add a Group to a Flex-RAID Volume
- Delete a RAID Group
- Use the Volume Management Wizard to Create a Volume
- Add a Tier to a Volume
- Enable or Disable Quotas on Volumes
- Maintain Volumes
- 3. Shares
- 4. LUNs
- 5. Snapshots
- 6. Users and Groups
- 7. Use Cloud Services
- 8. System Settings
- 9. System Power
- 10. Install and Manage Apps
- 11. System Monitoring
- 12. System Maintenance
- 13. Backup and Recovery
WARNING: During backup using the Rsync over Remote SSH protocol, specifying
an absolute path might overwrite existing files at that destination. Backing up
using the Rsync over Remote SSH protocol is for expert users only.
•
Do not use a backslash (\) in paths.
10. If necessary, enter the login credentials required to access the source or destination.
11. To determine if your ReadyNAS system can access the remote destination, click the
Test Connection button.
12. Click the Apply button.
Your settings are saved.
13. Click the OK button.
The pop-up window closes.
Configure Advanced Rsync Job Settings
You can configure advanced settings for jobs that use Rsync or Rsync over SSH.
To configure Rsync job settings:
1. Log in to the ReadyNAS.
2. Select Backup.
The page updates showing the list of backup and recovery jobs.
3. Mouse over the backup or recovery job and click the gear icon.
4. Click the Settings button.
The job settings window opens.
Software Manual280Backup and Recovery
ReadyNAS OS 6.10