User Manual

- If you select the NFS protocol, specify the export point followed by the path, for example:
/<export point>/path
- If you select the Rsync server protocol, specify the module name followed by the path, for
example:
<module name>/path
WARNING:
Backing up using the Rsync protocol is for expert users only.
- If you select the Rsync over Remote SSH protocol, specify the relative or absolute path, for
example:
- <relative path>
- /<absolute path>
WARNING:
During backup using the Rsync over Remote SSH protocol, specifying
an absolute path might overwrite existing files at that destination.
Backing up using the Rsync over Remote SSH protocol is for expert
users only.
- Do not use a backslash (\) in paths.
If you configured a remote destination, you can immediately test the connection by
clicking the Test Connection button.
Note
9. Click the Next button.
The New Backup Job: Schedule window displays.
10. Clear the Enabled check box.
Clearing this check box forces the recovery procedure to be started manually, which ensures that the
recovery job does not happen automatically.
WARNING:
To ensure the integrity of the data stored on your primary device, never
schedule a recovery job to run automatically.
Because you cleared the Enable check box, you must manually start the recovery
job. For information about manually starting a job, see Manually Start a Backup or
Recovery Job on page 253.
Note
Select the Finish button.
The New Backup Job: Schedule window closes and the recovery job is added to the Jobs list.
Backup and Recovery
242
ReadyNAS OS 6.9.3