User Manual

DescriptionItem
IPv6 settings
From the menu, select how IPv6 is configured:
• Automatically/DHCP. The ReadyNAS is configured with an IPv6 address through stateless
autoconfiguration without the requirement of a DHCPv6 server on your network.The ReadyNAS
must be connected to the Internet for stateless auto-configuration to function.
• Static.You must enter the IPv6 address and prefix length for the ReadyNAS and the router
through which the ReadyNAS is connected to the network.
• Disable. Disables IPv6 networking.
Configure
Manual configuration only.Enter the IPv6 address for the router through which the
ReadyNAS connects to your network.The default setting
is undefined.
Router
Enter the link local address range.IPv6
Link-Local
Enter the IPv6 address for the ReadyNAS.IPv6 Address
Enter the prefix length for the ReadyNAS.The default
prefix length is 64.
Prefix Length
Add a DNS server.+
Select a DNS server and click to remove that server.-
9. Click the Apply button.
Your settings are saved.
Configure Bonded Adapters
Creating a bonded adapter is optional. A bonded adapter combines two Ethernet interfaces into a single
logical link. Network devices treat the bonded adapter as a single link, which increases fault tolerance and
provides load sharing. NETGEAR does not recommend bonding interfaces with different speeds, for example
bonding a 1 Gb interface with a 10 Gb interface.
Bonding is available only on ReadyNAS systems with two or more Ethernet interfaces.Note
Teaming Modes
The ReadyNAS supports several teaming modes. Both the ReadyNAS and the device with which the bonded
adapter is linked must support the same teaming mode. The available teaming modes are described in the
following table.
System Settings
171
ReadyNAS OS 6.9.3