Operation Manual

Control Access to the Internet
85
Nighthawk DST AC1900 DST Router and DST Adpater Model R7300DST
9. Specify a new outbound rule as described in the following table.
Field Description
Protocol Select the protocol (TCP or UDP) that is associated with the service or
application. If you are unsure, select TCP/UDP.
Starting Port Enter the start port for the service or application.
Ending Port If the service or application uses a range of ports, enter the end port for
the range. If the service or application uses a single port, repeat the port
number that you entered in the Starting Port field.
Service Type/User
Defined
Enter the name of the custom service or application.
10. Specify which devices on your LAN (or LAN users) are affected by the rule, based on their
IP addresses:
• Only This IP Address. Enter the required address in the fields to apply the rule to a
single device on your LAN.
• IP Address Range. Enter the required addresses in the start and end fields to apply
the rule to a range of devices.
• All IP Addresses.
All computers and devices on your LAN are covered by this rule.
By default, the All IP
Addresses radio button is selected.
11. Click the Add button.
The new rule is added to the Service Table on the Block Services page.
Change an Outbound Firewall Rule
You can change an existing outbound firewall rule.
 To change an outbound firewall rule:
1. Launch a web browser from a computer or WiFi device that is connected to the network.
2. Enter http://www
.routerlogin.net.
A login window displays.
3. Enter the router user name and password.
The user name is admin.
The default password is password. The user name and
password are case-sensitive.
The BASIC Home page displays.