Operation Manual

Hardware Setup
15
Nighthawk DST AC1900 DST Router and DST Adpater Model R7300DST
DST Router Rear Panel
The connections and buttons on the read panel are shown in the following figure.
Power
connector
Power
On/Off
switch
Reset
button
Ethernet
ports 1–4
WAN
(Internet)
port
USB 2.0
port
LED
On/Off
button
Figure 3. DST router rear panel
DST Router Rear Panel Hardware Features
In addition to the three threaded antenna posts, the back panel contains the following:
• Power connector. Connect the power cord that came in the product package to the
power connector
.
• Power On/Off switch. Slide the Power On/Off switch to the On position to provide
power to the DST router.
• Reset button. Pressing the Reset button restores the factory settings. For more
information about using the Reset button, see Factory Settings on page 261.
• Ethernet ports. Four Gigabit Ethernet RJ-45 LAN ports to connect the DST router to
LAN devices.
• WAN (Internet) port. One Gigabit Ethernet RJ-45 W
AN port to connect the DST router to
a modem.