User Manual

Rear Panel
The following figure shows the rear panel connectors and buttons.
Figure 3. Rear panel
Viewed from left to right, the rear panel contains the following components:
•
Reset button. Pressing the Reset button resets the router.
If the Reset button is pressed for at least 10 seconds and the Power LED blinks white,
the router returns to its factory settings. For information about the factory settings,
see Factory Settings on page ?.
•
Ethernet ports. Four Gigabit Ethernet RJ-45 LAN ports. Use these ports to connect
the router to LAN devices.
•
Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the router to an
Internet modem such as a cable modem or DLS modem.
•
USB 2.0 port. Use this USB port to connect a USB storage device. A USB 3.0 port is
located on the front of the router.
•
Power On/Off button. Press the Power On/Off button to provide power to the
router.
•
Power connector. Connect the power adapter that came in the product package
to the power connector.
User Manual14Hardware Setup
Nighthawk AC1900 Smart WiFi Router Model R7000