Quick Reference Guide

Installation and Reference for the Model PS104/PS105/PS110/PS113 Print Server
C-2 CONFIG File
Subnet Mask
(4002 MASK)
If the Gateway Address is 0.0.0.0, leave the Subnet Mask at
0.0.0.0. If you have a router, enter the Subnet mask for the
segment to which the print server is attached.
TCP Session Retry Interval
(4010 TCP_INT)
Sets how long the print server should wait before retrying a
TCP/IP connection that is lost. Allowable values are from 0 to
255 seconds, with 2 as the default.
Retry Count
(4011 TCP_CNT)
Sets how many attempts for reconnection will be made. After
attempting the set number, the TCP/IP session is terminated.
Allowable values are from 0 to 255, with 254 as the default.
L1 Logical Printer Mapping
(0100 L1_PROUT)
The physical port that this L1 logical printer maps to.
String Before Job for L1 Logical Printer
(0101 L1_PREST)
The L1 logical printer control string (in hex) to be sent to the
printer before each print job. Note: A printer control string is
limited to 15 characters.
Examples are:
• ASCII = [Esc]&l0O
Hexadecimal = 1B266C304F
• ASCII = [Esc]&l1O
Hexadecimal = 1B266C314F
String After Job
(0102 L1_POSTR)
The L1 logical printer control string (in hex) to be sent to the
printer after each print job. Note: A printer control string is
limited to 15 characters.
Examples are:
• ASCII = [Esc]&l0O
Hexadecimal = 1B266C304F
• ASCII = [Esc]&l1O
Hexadecimal = 1B266C314F
Convert LF to CR+LF
(0103 L1_CHGLF)
If On, LF (line feed) characters are changed to CR+LF
(carriage return + line feed). If off, no conversion is done.
Table C-1. Configuration Settings (continued)
Parameter and Command Definition