Quick Reference Guide

CONFIG File C-1
Appendix C
CONFIG File
This appendix provides information for editing a CONFIG file. CONFIG files are stored in the
flash EEPROM of the NETGEAR Model PS104/PS105/PS110/PS113 print server and used for
configuring the device using the FTP method. For more information about using the CONFIG
file and to see an example of FTP commands, refer to “
Configuring Your Print Server Using FTP”
on page
6-7. Only the parameters related to TCP/IP operation of the print server are listed.
For modification of the various NetWare IPX/SPX and NetBEUI settings, NETGEAR
recommends that you use the included FirstGear Print Server Administration Program or the
PSCONFIG program.
CONFIG File TCP/IP Settings
When modifying the CONFIG file, use the configuration settings outlined in Table C-1.
Table C-1. Configuration Settings
Parameter and Command Definition
Device Name
(0001 BOX_NAME)
The default name of the print server is PSxxxxxx (PS followed
by 6 numbers). You can change this, but the new name must
not exceed 19 characters and must not include any spaces.
TCP/IP Protocol
(0012 TCPIP_P)
Enables or disables reception or transmission of TCP/IP
packets.
IP Address
(4000 IP_ADDR)
This is the IP address for your print server. For more
information about IP addressing, refer to Appendix
B,
“Understanding IP Addresses.”
Device IP Address
(4001 GATEWAY)
If your network segment has a router, enter the router address
here. If there is no router, leave the address as 0.0.0.0.