Quick Reference Guide

Installation and Reference for the Model PS104/PS105/PS110/PS113 Print Server
UNIX Printing Using TCP/IP 6-11
6. Print using the command:
lp -d printer_queue file_name
Use these definitions for entering the information:
• printer_queue is one of the entries used in Name of queue to add.
• file_name is the file you want to print.
Configuring LPD on System V
Before beginning LPD Setup, make sure that an IP address has been assigned to your print server
and that the following statements apply:
• The remote host name is the name of the print server.
• The remote printer name is the print queue name for the logical printer.
• Logical printers are configured on the print server itself.
• You identify the service type as BSD if your UNIX system asks for the LPD type.
The LPD protocol that the print server uses meets BSD system standards.
T
able 6-3 shows sample commands when using LPD. The definitions used in the sample
commands are:
• printer_name is the name of the print queue serviced by the print server.
• Spooler_directory is the name of the directory used to spool the print jobs.
Table 6-3. Sample Commands for Using LPD on System V
Action Sample Command
Stop Print Services /usr/lib/lpshut
Add a System Printer /usr/lib/lpadmin -p printer_name -v /dev/null
Restart the Print Services /usr/lib/lpsched
Enable printing to the new printer device enable printer_name
Start accepting jobs for the new printer device accept printer_name
Create a spooling directory mkdir /usr/spool/Spooler_directory
Make spooling daemon the owner of this directory chown daemon /usr/spool/Spooler_directory
Create read/write permissions chmod 775 /usr/spool/Spooler_directory