Quick Start Manual

Model PS104/PS105/PS110 Print Server Installation Guide
Using the BNC Network Port (Model PS105)
The BNC-T connector included in the package contents must be used with thin
coaxial cable for a 10BASE2 connection to other network devices that have a
BNC port. To terminate the connection on the last device in the network
segment, you must use the BNC terminator (also included in the package
contents).
Ethernet specifications limit the segment length of coaxial cable to 185 m, the
maximum distance between nodes to 0.5 m, and the maximum number of nodes
per segment to 30. Make sure the cable meets the specifications as outlined in
Installation and Reference for the Model PS104/PS105/PS110 Print Server on
the PS100 Series Print Server Resource CD.
Connect the power adapter first to the power receptacle on the rear panel of the
print server and then to the power outlet on the wall. When power has been
applied to the print server:
• The green Pwr (power) LED on the front panel is on.
• On the Model PS104 and Model PS105 print servers, the green Link/Rx
LED on each connected network port is on.
• On the Model PS110 Print Server, the Link LED on the connected network
port is on.
• The green Link/Act LED on the connected PRINTER, PRINTER 1, or
PRINTER 2 port is on.
If you find any problems, refer to “Troubleshooting Information.”
Make sure the network interface cards installed in the workstations are in
working condition and the software driver has been installed on the cards.
If required, verify the integrity of the print server by resetting it. Turn power to
the print server off and then back on. If the problem continues and you have
completed all the preceding diagnoses, contact NETGEAR Customer Support.
For the telephone number of the representative in your area, see the Support
Information Card that is included in your package contents.
Verify Power