Quick Reference Guide

NetGear Print Server Manual

4-2 NETGEAR Print Server Software Installation

NETGEAR Print Server software works for PS100 series Print Sever in a Microsoft Windows

networking environment.

To install and set up your network and your print server for the NETGEAR Print Server, you may use

a PC with a Microsoft Windows (95, 98, NT 4.0, ME, 2000, or XP) operating system and with either

the TCP/IP protocol or the NetBEUI protocol enabled.

Turn on the power to your PC.

Before proceeding with these instructions, be sure to assign a name to your

workgroup on your PC. NETGEAR strongly recommends that you exit all Windows

programs before running the Setup program. It is also necessary to install the

NETGEAR Print Server software on every PC in the network that will use the

printers attached to the PS100 series Print Sever.

Insert the CD ROM into the CDROM drive. The program should start automatically. If not, please

double click on setup.exe under the CDROM root directory. The first screen is shown below. Click on

Next button.

Figure 4-1 Print Server Installation