User's Manual
Table Of Contents
- ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Using the Setup Wizard to Provision the STM in Your Network
- Choosing a Deployment Scenario
- Understanding the Steps for Initial Connection
- Logging In to the STM
- Using the Setup Wizard to Perform the Initial Configuration
- Setup Wizard Step 1 of 10: Introduction
- Setup Wizard Step 2 of 11: Networking Settings
- Setup Wizard Step 3 of 11: Time Zone
- Setup Wizard Step 4 of 11: Email Security
- Setup Wizard Step 5 of 11: Web Security
- Setup Wizard Step 6 of 11: Email Notification Server Settings
- Setup Wizard Step 7 of 11: Update Settings
- Setup Wizard Step 8 of 11: HTTP Proxy Settings
- Setup Wizard Step 9 of 11: Web Categories
- Setup Wizard Step 10 of 11: Configuration Summary
- Setup Wizard Step 11 of 11: Restarting the System
- Verifying Proper Installation
- Registering the STM with NETGEAR
- What to Do Next
- Chapter 3 Performing Network and System Management
- Configuring Network Settings
- Configuring Session Limits and Timeouts
- Configuring the HTTP Proxy Settings
- About Users with Administrative and Guest Privileges
- Configuring Remote Management Access
- Using an SNMP Manager
- Managing the Configuration File
- Updating the Software
- Configuring Date and Time Service
- Managing Digital Certificates
- Managing the Quarantine Settings
- Performance Management
- Chapter 4 Content Filtering and Optimizing Scans
- About Content Filtering and Scans
- Configuring E-mail Protection
- Configuring Web and Services Protection
- Configuring Application Control
- Setting Scanning Exclusions and Web Access Exceptions
- Chapter 5 Managing Users, Groups, and Authentication
- About Users, Groups, and Domains
- Configuring Groups
- Configuring User Accounts
- Configuring Authentication
- Global User Settings
- Viewing and Logging Out Active Users
- Chapter 6 Monitoring System Access and Performance
- Chapter 7 Troubleshooting and Using Online Support
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
Monitoring System Access and Performance 6-19
v1.0, September 2009
3. Use the From pull-down menu to select the start date of the Web usage report (year, month,
date) and the To pull-down menu to select the end date of the report (year, month, date).
4. Click View. The STM generates a Web usage report.
The Web usage reports shows the following columns:
• TOP. The Web usage ranking.
• Category. The Web content filtering category.
• Requests. The number of requests for the category.
• % of Requests. The percentage of requests for the category in relation to the total number
of Web requests.
• IPs. The number of IP addresses that request the category.
• % of IPs. The percentage of IP addresses that request the category in relation to the total
number of IP addresses.
• Blocked. Whether or not the category is blocked by the STM.
Viewing System Status
The System Status screen provides real-time information about the following components of the
STM:
• Firmware versions and update information of the STM, software versions and update
information of the components, license expiration dates for each type of license, and hardware
serial number.
• Management interface information.
• MAC addresses for the STM’s interfaces.
To view the System Status screen click Monitoring > System Status. Figure 6-10 on page 6-20
displays the System Status screen of the STM600. The Interfaces section of the System Status
screen differs for STM300 and STM150 (see the explanation in Table 6-8 on page 6-21).