Switch User Manual
Table Of Contents
- FS728TP Smart Switch Software Administration Manual
- Contents
- About This Manual
- Chapter 1 Getting Started with Switch Management
- Chapter 2 Introduction to the Web Browser Interface
- Chapter 3 Managing System Settings
- Chapter 4 Configuring Switching Settings
- Chapter 5 Configuring QoS
- Chapter 6 Managing Security
- Chapter 7 Monitoring the Switch
- Chapter 8 Maintenance
- Chapter 9 Online Help
- Appendix A Default Settings
- Index
FS728TP Smart Switch Software Administration Manual
Managing Security 6-3
v1.1, September 2009
RADIUS
Remote Authorization Dial-In User Service (RADIUS) servers provide additional security for
networks. RADIUS servers provide a centralized authentication method for web access. The user-
assigned RADIUS parameters are applied to newly defined RADIUS servers. If values are not
defined, the system defaults are applied to the new RADIUS servers.
To configure RADIUS servers:
1. Click Security > Management Security > RADIUS. The RADIUS screen displays:
The RADIUS screen contains the following fields:
• Host IP Address – Enter the RADIUS Server IP address.
• Authentication Port – Enter the authentication port number. The authentication port is
used to verify the RADIUS Server authentication. The field default is 1812.
• Number of Retries – Enter the number of transmitted requests sent to the RADIUS
Server before a failure occurs. Possible field values are 1-10. The default value is 3.
Figure 6-2