Switch User Manual
Table Of Contents
- FS728TP Smart Switch Software Administration Manual
- Contents
- About This Manual
- Chapter 1 Getting Started with Switch Management
- Chapter 2 Introduction to the Web Browser Interface
- Chapter 3 Managing System Settings
- Chapter 4 Configuring Switching Settings
- Chapter 5 Configuring QoS
- Chapter 6 Managing Security
- Chapter 7 Monitoring the Switch
- Chapter 8 Maintenance
- Chapter 9 Online Help
- Appendix A Default Settings
- Index
FS728TP Smart Switch Software Administration Manual
4-42 Configuring Switching Settings
v1.1, September 2009
are forwarding packets and Multicast traffic. A port requesting to join a specific Multicast group
issues an IGMP report specifying that Multicast group. This results in the creation of the Multicast
filtering database.
To configure Basic IGMP Snooping:
1. Click Switching > Multicast > Basic > IGMP Snooping Configuration.
The Basic IGMP
Snooping Configuration screen displays:
The Basic IGMP Snooping Configuration screen contains the following fields:
IGMP Snooping Configuration
• IGMP Snooping Status – Select the IGMP Snooping status on the device. The possible
field values are:
– Disable – Disables IGMP Snooping on the device. This is the default value.
– Enable – Enables IGMP Snooping on the device.
Interface Settings
• VLAN ID – Displays the VLAN ID.
• Status – Select the IGMP Snooping status on the VLAN. The possible field values are:
Figure 4-23