Owner's Manual

030-300233 Rev. A 100 May 2006
Westell (Models 6000, 6100, 6110)
User Guide
14.4 Remote Access
The following screen will appear if you select Maintenance > Remote Access from the main menu. To enable
Remote Access, perform the following steps:
1. Enter the administrator’s password.
NOTE: The password should be at least 4 characters long and should not exceed 32 characters.
Do not type a blank space or asterisks in the Password field. The password is case sensitive.
2. Click the Enable Remote Access box (a check mark will appear in the box).
3. Click apply to allow the settings to take effect.
User Name Displays your current User Name (Static field)
Password Field for entering your password
Timeout The number of minutes after which remote access will be deactivated (if it has been
activated).
Disable Timeout Click this box (a check mark will appear) to activate the Disable Timeout feature.
Clear this box to deactivate this feature.
Enable Remote Access Click this box (a check mark will appear) to activate Enable Remote Access.
Clear this box to deactivate this feature.
Remote URL Displays the IP address of the remote management gateway
After you have clicked apply to enable Remote Access, the following message will appear:
Remote access is currently enabled. After 20 minutes of inactivity, or on
reboot, remote access will be automatically disabled.